We often get customers asking how to install the ends on their motorcycle spark plug wires, be in one of our vintage-style Cloth Covered Spark Plug Wire Sets or NGK spark plug caps on silicone wires. In this DIY Tech Tip, Todd, Lead Tech at Lowbrow Customs, explains how to assemble your spark plug wires, even if you do not have the special crimpers made for the terminal ends. Check out the
Step 3 – Set the spark plug gap. Using a wire-type spark plug gap tool, measure the gap on the new spark plugs. There should be a very slight drag on the gauge when passing a 0.040" (0.038"-0.043") gauge between the center and outer electrode. Bend the outside electrode with the tool to obtain proper gap. Figure 3.
Spark Plug Wire Set New Firing Order: 1, 3, 7, 2, 6, 5, 4, 8 For 1994 To 1996 Truck; To Eliminate The Possibility Of Crossfire Between Cylinders 1 And 3 Or 5 And 6, Do Not Put These Wires Next To Each Other In The Separators On The Valve Covers. 2 Year LIMITED WARRANTY. Core Material: Carbon. Noise Suppression: Yes. Wire Separators Included: No.
This is the way I do it. Use at your own discretion.You can also use doubled shrink tube, shrink tubing that has glue inside, even a brass "nail" if you like
Start at one end of the engine and remove only the first spark plug wire by pulling on the boot at the end of the wire until it pops off. Follow the wire with your hand to the other end and remove it from the distributor cap. Note that in some vehicles, this end of the spark plug wire is permanently attached to the distributor cap.
. 219 86 51 390 337 210 78 414
how to connect spark plug wires
